Cylinder Oil 600 W What Is For, What Will It Do 1920

GARGOYLE CYLINDER OIL 600 W Low cost of cylinder lubrication results from the use of Gargoyle Cylinder Oil 600 W, because of the low rate of feed, the small quantity required to maintain a complete lubricating film. The cost per cylinder, per hour of opera- tion is found to be at a minimum when Gargoyle Cylinder Oil 600 W is properly applied. Gargoyle Cylinder Oil 600 W possesses unusual character- istics that will enable it to readily atomize under a very wide range of conditions of steam pressure and steam tem- perature. It is specially manufactured to give its best service with steam pressures above 100 Ib. per square inch and high steam temperature, even up to a total steam temperature of 600° F. The unusual characteristics of Gargoyle Cylinder Oil 600 W permit its use for steam pressures below 100 Ib. per square inch, although it will not spread so readily as will other of our high grade cylinder oils, such as Gargoyle Val ve Oil and Gargoyle Cylinder Oil Rarus. These cylinder oils are specially made to suit conditions of low pressure, wet steam, etc., and therefore will give greater economy and efficiency than Gargoyle Cylinder Oil 600 W under these conditions. Gargoyle Cylinder Oil 600 W, when rightly applied and in the right quantity, will not form a carbonaceous deposit even under conditions of high steam pressure and super- heat, and will prevent excessive wear. Where pistons or valves fail to operate satisfactorily, be- cause of severe conditions, it is usually because the lubri- cating oil film gives way under excessive pressure or tem- perature. 15